1200w 20A Dc Boost Step-up Converter
SKU:
3398
In stock
Specification
- Module name: 1200W boost constant current module
- Module properties: non isolated boost module (BOOST)
- Input voltage: 10-60V
- Input current: 20A
- Quiescent operating current: 15mA
- Output voltage: 12-83V continuous adjustable
- Output current: MAX 12A over 20A, please strengthen the
- cooling (with input and output differential pressure, the greater
- the pressure difference between the output current is small)
- Constant current range: 0.3-20A
- Output power: = input voltage  x 10A
- Working temperature: -40~+85 degrees
- Working frequency: 150KHz
- Conversion efficiency: ≤95% (efficiency and input, output voltage,
- current, pressure difference)
- Installation: 4pcs 3mm column
- Connection mode: welding output (please use big current and pure copper wire)
- Module size: 130mmx52mmx46mm(LxWxH)
12V DC voltmeter range 8 – 30V LED Digital Voltage Panel Meter
SKU:
1143
In stock
300W 20A Step Down Buck Converter Module Voltage Regulator
SKU:
1392
In stock
300W Step Down Buck Converter Adjustable 9A
SKU:
1496
In stock
Material: PCB board and electronic component
Input voltage: 5-40V
Output voltage: 1.2-35V (continuously adjustable)
Output Current: 9A (power tube temperature exceeds 65°C please add cooling fan)
Constant current range:0.2-9A ( adjustable )
Output Power: Maximum power is about 300W (power tube temperature exceeds 65°C please add cooling fan)
5815M RDA5815M QFN-20 Signal IC Original DG series
SKU:
2836
In stock
5815M RDA5815M QFN-20 Signal IC
Single-chip RF-to-baseband Satellite receiver
CMOS Fully integrated RF front end
Low noise and wide dynamic range zero-IF receiver
Input frequency range: 900 to 2200 MHz
Input signal level: -100 to 5 dBm
More than 85dB gain control range
Fully integrated PLL (dividers, charge pump, phase & frequency detectors, loop filters, etc.)
Integrated RX VCO
Integrated baseband LPF with selectable cut-off frequency from 4MHz to 40MHz with 1MHz step
Integrated LNAwith RF AGC
Integrated reference oscillator (27MHz is defult) I 2C bus interface
Automatic gain control
0.11?m RF CMOS technology
3V to 3.6V operation
5v Micro USB 1A TP4056 Charging Board Module
SKU:
1061
In stock
CP2112 Evaluation kit for Debug CCS811 Board USB To I2C Communication Module
SKU:
2146
In stock
LM2596S Step Down LCD display Adjustable Power Module Voltmeter
SKU:
1078
In stock
MT3608 SOT23-6 B628 smd ic Synchronous Step Up Boost Converter DC-DC
SKU:
3055
In stock
MT3608 SOT23-6 B628 smd ic Synchronous Boost Converter DC-DC
Specifications
2V to 24V input voltage with output boost 5V to 28V adjustable
Maximum output current: 2A
Input voltage: 2V ~ 24V
Maximum output voltage: > 5V - 28V
Efficiency: > 93%
Input voltage should not exceed the maximum input voltage
Peak current output current should not more than 2A
Output voltage should always be higher than Input voltage
Power Bank Dual USB 5V 1A 2.1A 18650 Battery Charger PCB Accessories
SKU:
1122
In stock
Power Bank Dual USB 5V 1A 2.1A Mobile 18650 Battery Charger PCB Power Module Accessories(No LCD)
SKU:
1167
In stock
TP4056 5V 1A 18650 TYPE-C USB lithium Battery Charger Module Charging Board With Protection
SKU:
2963
In stock
TP4056 5V 1A 18650 TYPE-C USB lithium Battery Charger Module Charging Board With Protection
Input voltage: 4.35-6V (recommended voltage 5v)
Charge cut-off voltage: 4.2V +/- 1%
Maximum load current output: 1000 ma
Battery overcharge protection voltage: 4.28V
Battery Overcharge Boost Voltage: 4.00V
Battery discharge protection voltage: 3.0V
Battery discharge termination voltage: 3.2V
Battery: current 3A overcurrent protection
Board size: about 2.5 * 1.65CM
Indicator light: without charging the light not bright, the red light to recharge, it is full of green light.
Electronic Components All kind of modules and converter modules in Pakistan