Stepper Driver A4988 Stepper Motor Driver Module with Heatsink
Low RDS (On) Output
Automatic current decay mode detection / selection
Mix with slow current decay modes
Synchronous rectification for low power dissipation
Internal UVLO
Cross-current protection
3.3 and 5 V compatible logic supply
802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
MICRO USB is an international standard, most smartphone data lines have adopted this interface,
wide range of uses, this module easily be converted to conventional DIP2.54mm pin,
a great convenience to your application!
Brand new & high quality
Breadboard power supply module, compatible with 5 V, 3.3 V
Apply to MB102 breadboard
Input voltage: 6.5-12 V (DC) or USB power supply
Output voltage: 3.3V/5V can switch over
Maximum output current: <700 ma
Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V
Motor Drive Shield L293D for Arduino Duemilanove Mega / UNO
4-channel DC motor drives, stepper motor or 2 while driving two servos, You can mix:
DC motor driver quad and two steering gear
Drive two DC motor and stepper motor all the way and two-way steering gear
Drive two stepper motors and two servos
The RF receiver modules are widely used for data receiving and signal control. They are specified as preferred components in remote control garage, roller curtain, door locks, remote sensing, telemetry, industrial control and wireless security alarm industry.
Max voltage: 16V
Minimum voltage: 5V
Continuous current: 10A
Short maximum current: 20A (less than 10 seconds)
Speed control mode: PWM step-less speed regulation, can also be used to adjust the light
Control mode: speed control potentiometer (clockwise clicked open, continue to rotate clockwise from 1% to 99% speed)
Duty cycle: 0%-99% (0% position is the state of the switch off when the potentiometer is most on the left).
When the current is switched on, the 0.002A (long time no need to switch off the governor is no current).
Efficiency: the maximum efficiency is as high as 98%.
Volume: long 3cm (excluding potentiometer), width 2cm, height 1.4cm
Continuous Drain Current, VGS @ 10V = 110 A
Pulsed Drain Current = 390 A
At 25°C Power Dissipation = 200 W
Linear Derating Factor = 1.3 W/°C
Gate-to-Source Voltage = ± 20 V
Avalanche Current = 62 A
Repetitive Avalanche Energy = 20 mJ
dv/dt Peak Diode Recovery dv/dt = 5.0 V/ns
Operating Junction and Soldering Temperature, for 10 seconds = 300 (1.6mm from case )°C
sohail –
it is out of stock please make sure it is availabl…