Car Vehicle Bike Tools and Accessories
Arduino Nano V3.0 CH340 Micro USB buy in Pakistan
PKR 850
Out of stock
کسٹمر کو رقم ادائیگی سے پہلے پارسل کھولنے کی اجازت ہے
| Weight | 0.07 kg |
|---|
On Sale Products
Related products
5A XL4015 DC-DC DSN5000 Adjustable Step Down Module with heat sink
Electronic Components, Active Components, Integrated Circuits, Voltage Converters and Power Supplies
SKU:
1178
In stock
DIY mobile power, car power, communications equipment and power supply.
Technical Parameters:
Module Properties: Non-isolated step-down module (BUCK)
Rectification: Non-synchronous rectifier
Input voltage: DC 5V-30V
Output voltage: DC 0.8V-24V (Adjustable, Output < Input)
Output current:Rated current is 2.5A,(5A Max, If current is larger than 2.5A, eEnhancement of heat dissipation is required.)
3V to 5V to 9V 2A USB Output Voltage Step-up Module Boost Converter
Electronic Components, Active Components, Integrated Circuits, Voltage Converters and Power Supplies
SKU:
1177
In stock
Note:Output voltage must be higher than Input Voltage
Input Voltage:2-6V(less than 3V,output power cut down)
Output Voltage:3.3V-9V adjustable(Input voltage must less than output voltage)
Output Current:Rated 2000mA (2.8V-3V input, 5V output, 1500MA output,(single lithium battery higher 2600MAH input,5V output, output current can up to 2000MA)
Note:Output voltage higher than 6V,Please connect power first,then connect load line
TTP223 Touch Switch Button Module Single Channel Self Locking
SKU:
1148
In stock
This module is based on a touch detection IC (TTP223B) of Capacitive type touch jog switch module . This module default output low, the low-power mode to mode; when a finger touching the corresponding position, the module will output high and returns low again touch. Mode is switched to fast mode; when for 12 seconds without touching
ESP8266 esp-01 remote serial Port WIFI wireless module D185
SKU:
1124
In stock
802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
PAM8403 mini 5V digital amplifier board with switch potentiometer
SKU:
1117
In stock
4 Channel I2C Logic Level Converter IIC Module 5V to 3.3v 4ch
SKU:
1077
In stock
L293D Motor Drive Shield for Arduino
SKU:
1051
In stock
Motor Drive Shield L293D for Arduino Duemilanove Mega / UNO
4-channel DC motor drives, stepper motor or 2 while driving two servos, You can mix:
DC motor driver quad and two steering gear
Drive two DC motor and stepper motor all the way and two-way steering gear
Drive two stepper motors and two servos
433mhz rf wireless receiver transmitter module kit
SKU:
1031
In stock
DC-DC LM2596 Step-down Adjustable Module CC-CV
SKU:
1022
In stock
Fixed turn the lamp current to 0.1 times the value of the constant current (charge when used to identify whether the battery is full);
2. Increased input reverse polarity protection diode;
3. Using dedicated reference IC, and high-precision sampling resistor, so that the constant current is more stable, (20 degrees to 100 degrees, the constant current 1A, when the temperature drift of less than 1%).Particularly suitable for LED driver
*High-power LED constant current drive
*Lithium battery charger (including ferroelectric)
XM1584 MP1584EN Ultra-small size DC-DC step-down module 3A adjustable super LM2596
Electronic Components, Active Components, Integrated Circuits, Voltage Converters and Power Supplies
SKU:
1217
In stock
12V 8A Switch Dimmer Brightness Adjustable Controller for DC motor LED Strip Light
SKU:
1189
In stock
2 CHANNEL 5v RELAY Module 2-channel
SKU:
1042
In stock
Description
Technical parameters:
1. 20 digital input/output port RX and TX, D2 ~ D13, A0 ~ A5
2. 8 analog input port A0 ~ A7
3. 1 to the TTL level a serial port to send and receive port RX/TX
4. 6 PWM port, D3, D5, D6, D9, D10, D11
5. Using Atmel Atmega328P-AU microcontroller
6. Support serial download and ISP download
7. Support external 3.3V ~ 12V dc power supply
8. Support the Li-ion polymer batteries while direct connect Vcc Pin
9. 16 MHZ clock frequency
Packing Include:
1PC Arduino Nano micro USB
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.