Car Vehicle Bike Tools and Accessories
TTGO T-BASE ESP8266 WIFI WIRELESS MODULE 4MB FLASH I2C FOR ARDUINO buy in Pakistan
PKR 950
In stock
کسٹمر کو رقم ادائیگی سے پہلے پارسل کھولنے کی اجازت ہے
| Weight | 0.008 kg |
|---|
On Sale Products
Related products
F5 5MM Diffused Round DIP Diode LED Lamp Light Green Yellow Blue White Red Light Emitting Diode
SKU:
1190
In stock
150W DC-DC Boost Converter 10-32V to 12-35V 6A Step Up Voltage Charger Power
Electronic Components, Active Components, Integrated Circuits, Voltage Converters and Power Supplies
SKU:
1188
In stock
SN74HC595N 74HC595N 74HC595 DIP-16 SHIFT REGISTER IC
SKU:
1184
In stock
3V to 5V to 9V 2A USB Output Voltage Step-up Module Boost Converter
Electronic Components, Active Components, Integrated Circuits, Voltage Converters and Power Supplies
SKU:
1177
In stock
Note:Output voltage must be higher than Input Voltage
Input Voltage:2-6V(less than 3V,output power cut down)
Output Voltage:3.3V-9V adjustable(Input voltage must less than output voltage)
Output Current:Rated 2000mA (2.8V-3V input, 5V output, 1500MA output,(single lithium battery higher 2600MAH input,5V output, output current can up to 2000MA)
Note:Output voltage higher than 6V,Please connect power first,then connect load line
Soil moisture sensor Soil Hygrometer Humidity Detection module
SKU:
1176
In stock
soil humidity module to the environmental humidity is the most sensitive, generally used to detect soil moisture.
module in soil moisture can not reach the setting threshold, DO mouth output high level, when soil moisture more than setting threshold, module D0 output low level;
small plate digital output D0 can be directly connected with the single chip microcomputer, through the single chip microcomputer to detect the high and low level, thus to detect soil moisture;
ESP8266 esp-01 remote serial Port WIFI wireless module D185
SKU:
1124
In stock
802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
PAM8403 mini 5V digital amplifier board with switch potentiometer
SKU:
1117
In stock
4-Phase Stepper Motor and Driver Board ULN2003 Module Arduino
SKU:
1018
In stock
DC-DC LM2596 Step-down Adjustable Module CC-CV
SKU:
1022
In stock
Fixed turn the lamp current to 0.1 times the value of the constant current (charge when used to identify whether the battery is full);
2. Increased input reverse polarity protection diode;
3. Using dedicated reference IC, and high-precision sampling resistor, so that the constant current is more stable, (20 degrees to 100 degrees, the constant current 1A, when the temperature drift of less than 1%).Particularly suitable for LED driver
*High-power LED constant current drive
*Lithium battery charger (including ferroelectric)
12V 8A Switch Dimmer Brightness Adjustable Controller for DC motor LED Strip Light
SKU:
1189
In stock
5V 9V 12V 10A PWM DC Motor Speed Controller LED Dimmer Module Adjustable Speed Regulator
SKU:
1180
In stock
Max voltage: 16V
Minimum voltage: 5V
Continuous current: 10A
Short maximum current: 20A (less than 10 seconds)
Speed control mode: PWM step-less speed regulation, can also be used to adjust the light
Control mode: speed control potentiometer (clockwise clicked open, continue to rotate clockwise from 1% to 99% speed)
Duty cycle: 0%-99% (0% position is the state of the switch off when the potentiometer is most on the left).
When the current is switched on, the 0.002A (long time no need to switch off the governor is no current).
Efficiency: the maximum efficiency is as high as 98%.
Volume: long 3cm (excluding potentiometer), width 2cm, height 1.4cm
Description
Product Description:
TTGO T-BASE ESP8266 WIFI WIRELESS MODULE 4MB FLASH I2C FOR ARDUINO
Description:
- This product is a TTGO T-Base ESP8266 WiFi board.
- Compatible with Arduino, nodemcu, microPython and easy to program with microUSB on board.
- It has a 4MB flash and a UFL connector to connect the PCB antenna and external antenna on the board.
- It has a lipo-battery charging interface and has a charging current of up to 500mA.
Feature:
Products Name:TTGO T-BASE ESP8266 WIFI MODULE
Wireless online
4MB flash
External and PCB antenna
Lithium battery interface, 500mA maximum charging current
TTGO I2C port
Compatible with Arduino, MicroPython, NodeMCU.
Package includes:
1 x TTGO T-BASE ESP8266 WIFI MODULE
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.