Click to enlarge

16 Channel 12-bit PWM/Servo Driver-I2C interface PCA9685 module in Pakistan

PKR  1,200

In stock


Last updated: 9 March, 2024
x

کسٹمر کو رقم ادائیگی سے پہلے پارسل کھولنے کی اجازت ہے

SKU: 1969 Categories: ,

5V compliant, and still talks to a 3.3V microcontroller.
6 “address select” pins for configuring up to 62 ICs on a single I2C bus
PWM frequency adjustable up to approximately 1.6kHz
12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
Configurable as push-pull or open-drain output
Output enable pin available for outside-the-microcontroller “shut it down!” control.

Related products

1 Channel 5V Relay Module 1-Channel relay

,
SKU: 1027

In stock

PKR  180
1 Channel 5V Relay Module 1-Channel relay
Add to wishlist
Add to cart
Quick view

2 CHANNEL 5v RELAY Module 2-channel

, , ,
SKU: 1042

In stock

PKR  350
Relay contact capacity 250V10A. Relay output normally open, normally closed; • active low. 5V relay signal input voltage range :0-5V; • VCC system power. JD-VCC relay power. Default 5V relay. JD-VCC and VCC shorted
Add to wishlist
Add to cart
Quick view

4-Phase Stepper Motor and Driver Board ULN2003 Module Arduino

,
SKU: 1018

In stock

PKR  350
5V 4-Phase Stepper Step Motor + Driver Board ULN2003 with drive Test Module Machinery Board for Arduino Diameter: 28mm / 1.1in Voltage: DC 5V Length: 274mm / 10.8in Step Angle: 5.625 * 1/64 Reduction ratio: 1/64 DC Resistance: 200±7% (25)
Add to wishlist
Add to cart
Quick view

433mhz rf wireless receiver transmitter module kit

, ,
SKU: 1031

In stock

PKR  210

The RF receiver modules are widely used for data receiving and signal control. They are specified as preferred components in remote control garage, roller curtain, door locks, remote sensing, telemetry, industrial control and wireless security alarm industry.

Add to wishlist
Add to cart
Quick view

CMOS CAMERA OV7670 300KP VGA Camera Module

,
SKU: 1047

In stock

PKR  580
High sensitivity for low-light applications
Low voltage suitable for embedded applications
Standard SCCB interface compatible with I2C interface
RawRGB to RGB (GRB4: 2:2, RGB565/555/444), YUV (4:2:2) and YCbCr (4:2:2)output format
support VGA, CIF, and from CIF to 40x30 the size
Add to wishlist
Add to cart
Quick view

DC-DC LM2596 Step-down Adjustable Module CC-CV

,
SKU: 1022

In stock

PKR  350
Fixed turn the lamp current to 0.1 times the value of the constant current (charge when used to identify whether the battery is full); 2. Increased input reverse polarity protection diode; 3. Using dedicated reference IC, and high-precision sampling resistor, so that the constant current is more stable, (20 degrees to 100 degrees, the constant current 1A, when the temperature drift of less than 1%).Particularly suitable for LED driver *High-power LED constant current drive *Lithium battery charger (including ferroelectric)
Add to wishlist
Add to cart
Quick view

L293D Motor Drive Shield for Arduino

,
SKU: 1051

In stock

PKR  480
Motor Drive Shield L293D for Arduino Duemilanove Mega / UNO 4-channel DC motor drives, stepper motor or 2 while driving two servos, You can mix: DC motor driver quad and two steering gear Drive two DC motor and stepper motor all the way and two-way steering gear Drive two stepper motors and two servos
Add to wishlist
Add to cart
Quick view

MB102 Breadboard Power Supply Module 3.3V 5V Bread Board

, ,
SKU: 1058

In stock

PKR  180
Brand new & high quality Breadboard power supply module, compatible with 5 V, 3.3 V Apply to MB102 breadboard Input voltage: 6.5-12 V (DC) or USB power supply Output voltage: 3.3V/5V can switch over Maximum output current: <700 ma Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V
Add to wishlist
Add to cart
Quick view
Description

16 Channel 12-bit PWM/Servo Driver-I2C interface PCA9685 module

  • 5V compliant, and still talks to a 3.3V microcontroller.
  • 6 “address select” pins for configuring up to 62 ICs on a single I2C bus
  • PWM frequency adjustable up to approximately 1.6kHz
  • 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
  • Configurable as push-pull or open-drain output
  • Output enable pin available for outside-the-microcontroller “shut it down!” control.

 Package Included:

  • 1PC 16 Channel 12-bit PWM/Servo Driver-I2C interface PCA9685 
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “16 Channel 12-bit PWM/Servo Driver-I2C interface PCA9685 module”

Your email address will not be published. Required fields are marked *

You have to be logged in to be able to add photos to your review.

16 Channel 12-bit PWM/Servo Driver-I2C interface PCA9685 module

  • 5V compliant, and still talks to a 3.3V microcontroller.
  • 6 “address select” pins for configuring up to 62 ICs on a single I2C bus
  • PWM frequency adjustable up to approximately 1.6kHz
  • 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
  • Configurable as push-pull or open-drain output
  • Output enable pin available for outside-the-microcontroller “shut it down!” control.

 Package Included:

  • 1PC 16 Channel 12-bit PWM/Servo Driver-I2C interface PCA9685