HC-06 HC06 HC 06 Bluetooth Serial 4 Pin Module

SKU: 1101

In stock

PKR  680
With VCC, GND, TXD, RXD foot for the bluetooth. With LED indicator light. 3.3V LDO baseboard. Input voltage 3.3-6V, the input voltage more than 7V is prohibited. Unpaired current is about 30mA, matched current is about 10mA.

4 Channel I2C Logic Level Converter IIC Module 5V to 3.3v 4ch

SKU: 1077

In stock

PKR  100
4 channel IIC I2C Logic Level Converter Bi-Directional Module 5V to 3.3V For Arduino

Four MOS tube : four channel , two-way conversation 3V and 5V
The power input with anti-reverse protection, integrated 3.3VLDO,and provide

HC-09 Bluetooth Serial Module Compatible With HC-07 HC-06

SKU: 1076

In stock

PKR  800
Mainstream CSR Bluetooth chip, Bluetooth V2.0 protocol standards

2, serial module operating voltage 3.3V.

3, the baud rate can be set 2400,4800,9600,19200,38400,57600,115200,230400 user

4 core module size: 28mm x

HC-05 HC05 Bluetooth JY-MCU 6 Pin Module

SKU: 1069

In stock

PKR  750
Serial port Bluetooth, Drop-in replacement for wired serial connections, transparent usage. You can use it simply for a serial port replacement to establish connection between MCU and GPS, PC to your embedded project and etc.

HC-06 has be

MB102 Breadboard Power Supply Module 3.3V 5V Bread Board

SKU: 1058

In stock

PKR  180
Brand new & high quality Breadboard power supply module, compatible with 5 V, 3.3 V Apply to MB102 breadboard Input voltage: 6.5-12 V (DC) or USB power supply Output voltage: 3.3V/5V can switch over Maximum output current: <700 ma Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V

Micro SD Card Mini TF Card Reader Module Spi Interfaces Arduino

SKU: 1057

In stock

PKR  170
Module features are as follows: 1. Supports Micro SD cards, Micro SDHC card (high speed card) 2 level conversion circuit board that interfaces level for 5V or 3.3V 3 power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board 4 is a standard communication interface SPI interface 5.4 M2 screw positioning holes for easy installation

L293D Motor Drive Shield for Arduino

SKU: 1051

In stock

PKR  480
Motor Drive Shield L293D for Arduino Duemilanove Mega / UNO 4-channel DC motor drives, stepper motor or 2 while driving two servos, You can mix: DC motor driver quad and two steering gear Drive two DC motor and stepper motor all the way and two-way steering gear Drive two stepper motors and two servos

CMOS CAMERA OV7670 300KP VGA Camera Module

SKU: 1047

In stock

PKR  580
High sensitivity for low-light applications
Low voltage suitable for embedded applications
Standard SCCB interface compatible with I2C interface
RawRGB to RGB (GRB4: 2:2, RGB565/555/444), YUV (4:2:2) and YCbCr (4:2:2)output format
support VGA, CIF, and from CIF to 40x30 the size

2 CHANNEL 5v RELAY Module 2-channel

SKU: 1042

In stock

PKR  350
Relay contact capacity 250V10A. Relay output normally open, normally closed; • active low. 5V relay signal input voltage range :0-5V; • VCC system power. JD-VCC relay power. Default 5V relay. JD-VCC and VCC shorted

Micro Servo SG90 9G Electronic RC DIY Robot

SKU: 1041

In stock

PKR  380
Micro Servo SG90 9G Eletronico Module RC Boat DIY Kit Robot Motor RC-Micro-Motor Servo Motor Mini Robots Towerpro SG90 9gSize: 23 X 12.2 X 29 mmOperating speed: 0.3second/ 60degreeStall Torque : 1.5kg/cmTemperature range: 0 ~ +55 degreeDead band width: 10usecOperating voltage: 4.2V~6V

433mhz rf wireless receiver transmitter module kit

SKU: 1031

In stock

PKR  210

The RF receiver modules are widely used for data receiving and signal control. They are specified as preferred components in remote control garage, roller curtain, door locks, remote sensing, telemetry, industrial control and wireless security alarm industry.

Transparent Box Case Shell for Arduino UNO R3 Good Quality

SKU: 1026

In stock

PKR  200
Dimensions: 79.5 x 64.5 x 21mm Material: A grade acrylic sheet For Arduino UNO R3 Development Board only