W25Q64 64Mbit 8MByte Storage FLASH interface module SPI BV FV
SKU:
2325
In stock
TTGO T-BASE ESP8266 WIFI WIRELESS MODULE 4MB FLASH I2C FOR ARDUINO
SKU:
2297
In stock
RS485 to TTL Converter Module MAX485 Module
SKU:
2261
In stock
SOP-8 ATMEL AT93C56A AT93C56 93C56 SOP8 IC/SMD EEPROM
SKU:
2157
In stock
The AT93C56 provides 2048 bits of serial electrically erasable programmable read-only memory (EEPROM), organized as 128 words of 16 bits
each (when the ORG pin is connected to VCC), and 128 words of 8 bits each
(when the ORG pin is tied to ground). The device is optimized for use in many industrial and commercial applications where low-power and low-voltage operations are
essential. The AT93C56 is available in space-saving 8-lead PDIP, 8-lead
JEDEC SOIC, 8-lead EIAJ SOIC, 8-lead MAP, 8-lead TSSOP, and 8-lead dBGA2
packages.
Tiny RTC I2C DS1307 Clock AT24C32 Memory Module for Arduino
SKU:
2048
In stock
SOP8 turn DIP8 / SOIC8 to DIP8 IC adapter Socket so8/tssop8/soic8/sop8 TO without pin
SKU:
2046
In stock
SOP8 turn DIP8 / SOIC8 to DIP8 IC adapter Socket so8/tssop8/soic8/sop8 TO without pin
Description:
SO8 SOP8 SSOP8 TSSOP8 SMD To DIP8 Adapter with pin 0.65/1.27mm PCB Board TL866A TL866CS TOP3000Product Name:100PCS SOP8 turn DIP8 / SOIC8 to DIP8 IC adapter Socket so8/tssop8/soic8/sop8 TO without pin
Package Size:12.0 * 12.0 * 8.0 ( cm )
Gross Weight/Package:0.06 ( kg )
Universal Box Power Supply Circuit Board SMPS for Free to Air D2H, DTH, Tata Sky Satellite Receiver 4 pin
SKU:
2023
In stock
Real-time Timing Switch Relay Module Control Clock Synchronization Delay Timer Controller Board DC 5V
SKU:
2007
In stock
Real-time relay timing and clock synchronization time control delay 24H timing 5 time periodsProduct Highlights:
Wide voltage power supply 5.0V ~ 60V;
A mode can be set for multiple time periods, can reach 5 time periods;
With a buzzer alarm function.Mode introduction:
OPE: relay closing time point, CLE: relay off time point
Time period: PE-1 ~ PE-5 5 time periods (OPE to CLE is a time period)
WeMos D1 Esp-Wroom-02 Motherboard ESP8266 Mini WiFi Nodemcu Module with 18650 Battery holder
SKU:
1965
In stock
One AD inputs.
Micro USB inputs.
One programmable LED (D0).
AUTO PROGRAM circuit.
ESP8266 (ESP-WROOM-02 With TELEC) is equivalent to the NodeMCU.
Analog Input (AD): Built-in dividing resistor (AD = 220K – ADC – 100K = GND).
There is a SOLDER terminal for SLEEP MODE.
Compatible With Arduino and NodeMCU.
Operation and charging are possible at the same time.
18650 charging circuit including the 5V boosting circuit with TP5410.
Overcharge protection, over-discharge protection built in.
LED: Red = Charging, Green = Full charging.
3000 mA 18650 It is possible to operate for more than 17 hours on a battery.
Integrated 18650 battery charging and discharging system.
One switch controls whether the 18650 battery is powered or not.
OLED’s SDA and SCL connected to the D1 pin and the D2 pin respectively.
The five buttons are controlled by FLATH, RSET, D5, D6, and D7 respectively.
The 5 Digital pins can configure the write/read/interrupt/PWM/I2C/one-wire supported separately.
Operation and NodeMCU consistent, adding a programmable LED, you can use GPIO16 to control, display 8266 running status and other functions. Integrated OLED and five buttons, more convenient for development.
The design concept originates from the open source project NodeMCU, and the development board integrates 18650 charging and discharging systems with charging and discharging protection. At the same time, an OLED and five directional buttons are integrated to facilitate the development.
Torch lens 23mm High Power LED Lens Reflector Collimator for flash light
SKU:
1879
In stock
DC 100V 50A Red Blue Digital Voltmeter Ammeter 2 in1 DC Volt Amp Meter With Shunt
SKU:
1746
In stock
Operating voltage:DC 4 ~ 30V
Measure voltage: DC 0 ~ 100V
Minimum resolution(V): 0.1V
Measure current :50A (require external shunt)
Minimum resolution(A): 0.1A
Operating current: <20mA
Display: three 0.28" LED digital tube
Display color: Red and Blue (two-color display)
Refresh rate: about 300mS / times
Measure accuracy: 1% (± 1 digit)
Operating temperature: -10 to 65° c
Operating Humidity: 10 to 80% (non-condensing)
Working pressure: 80 to 106 kPa
Applications:Suitable for automotive/electric cars/motorcycles battery monitoring or other products voltage current measurement