Car Vehicle Bike Tools and Accessories
XM1584 MP1584EN Ultra-small size DC-DC step-down module 3A adjustable super LM2596 buy in Pakistan
PKR 150
In stock
کسٹمر کو رقم ادائیگی سے پہلے پارسل کھولنے کی اجازت ہے
| Weight | 0.005 kg |
|---|
On Sale Products
Related products
HX711 Weighing & Pressure Sensor 24-bit Precision A/D Module
SKU:
1224
In stock
Two selectable differential input channels.
There is no programming needed for the internal registers. All controls to the HX711 are through the pins.
Simultaneous 50 and 60Hz supply rejection.
Current consumption including on-chip analog power supply regulator: normal operation < 1.5mA, power down < 1uA.
Operation supply voltage range: 2.6 ~ 5.5V.
Operation temperature range: -40 ~ +85℃.
F5 5MM Diffused Round DIP Diode LED Lamp Light Green Yellow Blue White Red Light Emitting Diode
SKU:
1190
In stock
5A XL4015 DC-DC DSN5000 Adjustable Step Down Module with heat sink
Electronic Components, Active Components, Voltage Converters and Power Supplies, Integrated Circuits
SKU:
1178
In stock
DIY mobile power, car power, communications equipment and power supply.
Technical Parameters:
Module Properties: Non-isolated step-down module (BUCK)
Rectification: Non-synchronous rectifier
Input voltage: DC 5V-30V
Output voltage: DC 0.8V-24V (Adjustable, Output < Input)
Output current:Rated current is 2.5A,(5A Max, If current is larger than 2.5A, eEnhancement of heat dissipation is required.)
Soil moisture sensor Soil Hygrometer Humidity Detection module
SKU:
1176
In stock
soil humidity module to the environmental humidity is the most sensitive, generally used to detect soil moisture.
module in soil moisture can not reach the setting threshold, DO mouth output high level, when soil moisture more than setting threshold, module D0 output low level;
small plate digital output D0 can be directly connected with the single chip microcomputer, through the single chip microcomputer to detect the high and low level, thus to detect soil moisture;
PAM8403 mini 5V digital amplifier board with switch potentiometer
SKU:
1117
In stock
LM2596 DC Adjustable Step-Down 3A Power Supply Module
SKU:
1062
In stock
Conversion efficiency: Up to 92% (output voltage higher, the higher the efficiency)
Switching Frequency: 150KHz
Rectifier: Non-Synchronous Rectification
Module Properties: Non-isolated step-down module (buck)
Short circuit protection: current limiting, since the recovery
Operating temperature: Industrial grade (-40 to +85 ) (output power 10W or less)
Full load temperature rise: 40
MB102 Breadboard Power Supply Module 3.3V 5V Bread Board
SKU:
1058
In stock
Brand new & high quality
Breadboard power supply module, compatible with 5 V, 3.3 V
Apply to MB102 breadboard
Input voltage: 6.5-12 V (DC) or USB power supply
Output voltage: 3.3V/5V can switch over
Maximum output current: <700 ma
Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V
L293D Motor Drive Shield for Arduino
SKU:
1051
In stock
Motor Drive Shield L293D for Arduino Duemilanove Mega / UNO
4-channel DC motor drives, stepper motor or 2 while driving two servos, You can mix:
DC motor driver quad and two steering gear
Drive two DC motor and stepper motor all the way and two-way steering gear
Drive two stepper motors and two servos
Micro Servo SG90 9G Eletronic Module RC DIY Kit Robot Motor Tower
SKU:
1041
In stock
DC-DC LM2596 Step-down Adjustable Module CC-CV
SKU:
1022
In stock
Fixed turn the lamp current to 0.1 times the value of the constant current (charge when used to identify whether the battery is full);
2. Increased input reverse polarity protection diode;
3. Using dedicated reference IC, and high-precision sampling resistor, so that the constant current is more stable, (20 degrees to 100 degrees, the constant current 1A, when the temperature drift of less than 1%).Particularly suitable for LED driver
*High-power LED constant current drive
*Lithium battery charger (including ferroelectric)
5V 9V 12V 10A PWM DC Motor Speed Controller LED Dimmer Module Adjustable Speed Regulator
SKU:
1180
In stock
Max voltage: 16V
Minimum voltage: 5V
Continuous current: 10A
Short maximum current: 20A (less than 10 seconds)
Speed control mode: PWM step-less speed regulation, can also be used to adjust the light
Control mode: speed control potentiometer (clockwise clicked open, continue to rotate clockwise from 1% to 99% speed)
Duty cycle: 0%-99% (0% position is the state of the switch off when the potentiometer is most on the left).
When the current is switched on, the 0.002A (long time no need to switch off the governor is no current).
Efficiency: the maximum efficiency is as high as 98%.
Volume: long 3cm (excluding potentiometer), width 2cm, height 1.4cm
2 CHANNEL 5v RELAY Module 2-channel
SKU:
1042
In stock
Description
XM1584 MP1584Mini Ultra-small size DC-DC step-down 3A Adjustable Power Supply Module
Uses:
DIY mobile power, monitor power supply, power buggies, camera power supply, car power, communications equipment supply, various right size and weight for demanding applications (such as aviation models, etc.).
Input voltage: 4.5-28V
Output Voltage: 0.8-20V (adjustable)
Output current: Rated current 3A(MAX).
Switching Frequency: 1MHz
Output Ripple: less than 30mV
Efficiency: 96%(max)
Operating temperature: Industrial grade (-40 C to +85 C)
Module Properties: Non-isolated step-down module (buck)
Size: 22 x 17 x 4mm
Package included:
Mini 3A DC-DC Converter Power Supply Module
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.