L9110 Dual Channel DC Motor Driver H bridge Controller Board

The L9110S 2-Channel motor driver module is a compact board that can be used to drive small robots. This module has two independent motor driver chips which can each drive up 800mA of continuous current. The boards can be operated from 2.5V to
12V enabling this module to be used with both 3.3V and 5V microcontrollers.
A set of female header pins is used to connect this module to a microcontroller.
The motors are attached via two sets of screw terminals.
A PWM Pulse Width Modulation signal is used to control the speed of a motor and a digital output is used to change its direction. This module can also be used to
drive a single four line two phase stepper motor. Four holes make this board easy to
mount onto your robot or other project.

On-board 2 L9110 motor control chip
Module can be driven by two dc motors at the same time or one phase 4 line 2type stepping motor
Input voltage: 2.5-12V DC
Each channel has a continuous output current 800 ma
PCB Size: 29.2mm x 23mm

Package Included:
1 X L9110  2 Channel Motor Driver